Getting system errors after upgrading
Posted: 2011-05-03T07:31:52-07:00
I upgraded to imagemagick 6.6.9-7 16 bit dynamic and ghostscript 9.01 this morning on windows server. On bootup, I am now getting a window that keeps popping up the says convert.exe encountered a problem and need to stop. When I close the window, it pops up again. After about 10 times, it finally stayed closed. I am also now getting an error in my system log that says SideBySide Dependent Assembly Microsoft.VC80.MFCLOC could not be found and Last Error was The referenced assembly is not installed on your system.
Imagemagick seems to be working fine.
Any suggestions?
Imagemagick seems to be working fine.
Any suggestions?