ImageMagickObject.dll standalone?
Posted: 2018-06-07T14:11:07-07:00
Hi All,
Does anybody know if it is possible to distribute just the "ImageMagickObject.dll" to get the COM+ functionality on various systems?
I am trying to figure out if this file is enough to use its functionality, or the full IM installation is required on top of it?
With no IM installed, I tried to register the ImageMagickObject.dll object via:
(with correct file path)
but I get this error:
---
The module [...] failed to load.
Make sure binary is stored at the specified path or debug it to check for problems with binary or dependent .DLL
The specified module could not be found
---
Anyone tried using the object as stand-alone without having the IM installed ?
thank you
Does anybody know if it is possible to distribute just the "ImageMagickObject.dll" to get the COM+ functionality on various systems?
I am trying to figure out if this file is enough to use its functionality, or the full IM installation is required on top of it?
With no IM installed, I tried to register the ImageMagickObject.dll object via:
Code: Select all
regsvr32 /c /s ImageMagickObject.dllbut I get this error:
---
The module [...] failed to load.
Make sure binary is stored at the specified path or debug it to check for problems with binary or dependent .DLL
The specified module could not be found
---
Anyone tried using the object as stand-alone without having the IM installed ?
thank you